| |
|
Manufacturing Quality Rubber Art-Stamps Since 1981
|
|
SPECIAL CLEARANCE AREA:
EVERYTHING ONLY 99¢ - $1.99!
|
|
| |
|
-
-
PANEL
B represents the back of the card.
-
The
heart was stamped onto PANEL C, positioned slightly below
its center.
-
Stamp
the heart again in PANEL A, being sure to place in the
same position as PANEL C.
-
On
PANEL A, cut a slot near the bottom of the heart, as indicated
by
the blue dotted line.
-
On
PANEL C, cut around the heart as indicated by the blue
dotted line.
You are cutting the bottom half of the card away.
-
-
Turn
card over and tuck the point of the heart in PANEL C into
the slot in PANEL A.
-
Add
the wedding bears to the card with foam mount to complete.
See a CARD EXAMPLE using
this Technique
|
 previous tip •  • next tip 
This Tip/Techniuqe has been provided courtesy of The Stampin' Place • www.stampin.com
Copyright © The Stampin' Place / The Stamp Pad Co,.Inc.• Big Lake, MN USA
Material may not be reproduced without written permission from The Stamp Pad Co., Inc.
|
|
|
|
The Stampin’ Place Custom & Rubber Art Stamps •
P.O. Box 43 • Big Lake, MN 55309 USA • info@stampin.com
Copyright ©1996-2009 The Stampin'
Place / The Stamp Pad Co,.Inc.• Big Lake, MN USA
Material may not be reproduced without written permission.
Linking to this website for commercial use is prohibited. Wholesale Inquiries
|
|
