| |
No Discounts Available for items in this area.
Return to > Custom Stamp Menu
Reinkers for
Self-Inking or Pre-inked Stamp Mounts |
Ideal Reinker for
umark Self-inking
Mount
2 oz. $3.95
How to reink your self-inking stamp:
 Push the top of the unit down approximately 1/8".
Push the buttons (located on each side) inward to lock
the unit in place.Push
the pad out from either side.Replace the old pad or
apply Maxum ink to the face of the old pad. Allow 5
minutes to soak in and insert back into the self-inker.
Press down on the top of the unit and the locks release
automatically.
For best results use Ideal
Ink only.
Other types of ink may damage your stamp.
Self-inking mounts are perfect for many
applications.
These sturdy plastic devices are ergonomically designed
to fit comfortably in your hand.
The type of paper
the impression is made on will determine it's drying
time. Your stamp is not intended for use with glossy
paper.
|
Reinker for
istamp Pre-ink
Mount
1/2 oz. $5.00
How to reink your pre-inked stamp:
 Remove the handle and place the required amout of
ink in the ink ports. Sizes do vary, so the amount of
ink is determined by the size/model number. Divide
the quantity of drops between the two ink ports.For
ink amounts, see below. Let the stamp sit overnight. If
the impression is still too light, repeat. Always reink
with the same color as the original stamps. Leave stamp
in upright position after inking.
For Models 75, 325 = 3-4
Drops
115, 125, 145 = 4-6 Drops
185 = 6-8 Drops • 245 = 10-12 Drops
For best results use i-stamp preink
Ink only.
Other types of ink may damage your stamp.
Other points to consider about
a pre-inked stamp:
-
The type of paper
the impression is made on will determine it's drying
time. Your stamp is not intended for use with glossy
paper.
-
The dust cover
allows you to keep your stamp clean when not in use.
If the surface of the stamp does get dirty, place cellophane
tape directly on the stamp surface and remove. The tape
will remove the loose particles and enable the stamp
to make better impressions.
-
If you get ink
on your fingers, use rubbing alcohol and then soap and
water.
-
To avoid stains,
keep away from clothing.
-
Keep your pre-ink
stamp away from children
|
Return to > Custom Stamp Menu > Stamp Pads & Inks Business Menu
Business Stamp Pads & Reinkers
General All Purpose Stamping Ink
Large size to accomodate large stamps. 4-1/2" x
7-1/4".
Great for office applications.
Reinkers Available.
Return to > Custom Stamp Menu > Stamp Pads & Inks Business Menu
All
Purpose Permanent • Photo Marking Stamping Kits
|
All Purpose Permanent
Stamping Kit
Fade & Water Resistant
Acid Free • Reconditioner
Crisp Impressions • Quick Drying
Kit includes:
• 2 oz. Permanent Ink
(Ultra Perm Opaque #667)
• 2 oz. Reconditioner
• Industrial Stamp Pad
for Solvent Based Ink
Cloth Pad, 3-1/2" h x 4-1/2"w
All Purpose Permanent Ink leaves a permanent
crisp impression on most porous and non-porous surfaces. All
Purpose Permanent Ink is recommended for the following surfaces:
plastic, wood, coated paper, coatings, metals, photos, fabrics,
as well as many other surfaces. Inked impressions will dry
within 20 seconds. A reconditioner is provided to rejuvenate
pad when solvents evaporate. |
Photo Marking
Stamping Kit
Fade & Water Resistant •
Acid Free
Reconditioner • Crisp Impressions
Quick Drying • Rub resistant
Kit includes:
• 2 oz. Photo Marking Ink
(Crown Super Marking Ink #445)
• 2 oz. Reconditioner
• Industrial Stamp Pad
for Solvent Based Ink
Cloth Pad, 3-1/2" h x 4-1/2"w
Photo Marking Ink leaves a permanent
stamped impression on photos. The impression will dry within
30 seconds. This ink will leave a permanent mark on many other
porous and non porous surfaces. A reconditioner is provided
to rejuvenate pad when solvents evaporate. |
|
Rubber Stamp Die is Recommended
for use with these inks.
Warning: Flammable liquid. Avoid prolonged contact with skin.
Use in well ventilated area.
Avoid contact with eyes. Keep out of reach of children. For
industrial use only. |
|
|
|
Return to > Custom Stamp Menu > Stamp Pads & Inks Business Menu
Industrial
Stamp Pads
For use with heavy bodied & highly corrosive
inks. Wooden base with muslin-wrapped felt pad.
Ideal for use with
large stamps. Sold in pairs, so that they can be placed face-to-face
to keep ink moist
when not in use. Available Dry (not inked). May
be used with any of our inks.
Invisible
Body Stamping Ink Pad • Reinker • Blacklight Invisible Body Stamping
Ink Pad or 2 oz. Ink Bottle
Great for event use • Non-Toxic
Portable UV Blacklight
Size: 6" x 2" x .5" • Weight: 0.3 lbs
High Output UV Bulb • Portable & Lightweight
Built-in Flashlight • Operates on 4 "AA"
Batteries (not included).
Tattoo
Ink Stamp Pads / Reinkers
Temporary tattoo stamping is easier and faster than body paints and they look very realistic.
Tattoo Pads create penetrating skin colors that wash off easily with soap and water.
Tattoo Pads ink dries in seconds, but the image can last for days!!
Hours of fun for kids, teens and playful adults
|
|
